126 SV650K7/SK7/AK7/SAK7 (’07-MODEL)
ABS CONTROL UNIT/HU
REMOVAL
!
%
• Remove the front seat. (#SV650/SK3 7-4)
• Remove the battery.
• Disconnect the following parts from the battery case
1.
2 Fuse box
3 Starter relay
4 Fuel pump relay
5 ABS motor relay fuse
6 ABS valve relay fuse
7 Rubber seat
• Remove the fasteners.
• Disconnect the relay box
8, ECM
9 and TO sensor
0 from
the battery case.
• Remove the battery case
1.
When storing the brake fluid, seal the container completely and keep away from children.
* This brake system is filled with an ethylene glycol-based DOT 4 brake fluid. Do not mix differ-
ent types of fluid such as silicone-based or petroleum-based.
* Do not use any brake fluid taken from old, used or unsealed containers. Never reuse brake
fluid left over from the last servicing or stored for long periods.
* Handle brake fluid with care: the fluid reacts chemically with paint, plastics, rubber materials
etc. and will damage then severely.
* The ABS is made up of many precision parts; never subject it to strong impacts or allow it to
become dirty or dusty.
* The ABS control unit/HU cannot be disassembled.
SAMPLE
To Next Page
Loading...
