128 SV650K7/SK7/AK7/SAK7 (’07-MODEL)
INSTALLATION
Installation is in the reverse order of removal. Pay attention to
the following points.
• Tighten the brake pipe flare nuts
1 to the specified torque.
& Brake pipe flare nut: 16 N·m (1.6 kgf-m, 11.5 lb-ft)
%
• Bleed air from the brake fluid circuit.
(#SV650/SK3 2-27 and -28)
!
* Route the brake hoses and pipes correctly.
(#Page 135 to 137)
* Make sure to hold the brake pipe when tightening the
flare nut, or it may be misaligned.
Never ride the motorcycle before bleeding the air.
SAMPLE
To Next Page
Loading...
