Suzuki SV650A - Page 26

SV650K7/SK7/AK7/SAK7 (’07-MODEL) 25
4) Disconnect the IAP sensor coupler.
5) Turn the ignition switch ON.
6) Measure the voltage at the Red wire

3 and ground.
7) Also, measure the voltage at the Red wire

3 and B/Br wire

4.
$ IAP sensor input voltage: 4.5 – 5.5 V
(

+ Red –

- Ground)
(

+ Red –

- B/Br)
" 09900-25008: Multi-circuit tester set
' Tester knob indication: Voltage (()
Is the voltage OK?
Step 2
1) Connect the IAP sensor coupler.
2) Insert the needle pointed probes to the lead wire coupler.
3) Start the engine at idle speed and measure the IAP sensor
output voltage at the wire side coupler.
(Front cylinder side: between G/B and B/Br wires)
(Rear cylinder side: between G/Y and B/Br wires)
$ IAP sensor output voltage: Approx. 2.5 V at idle speed
(Front cylinder side:

+ G/B –

- B/Br)
(Rear cylinder side:

+ G/Y –

- B/Br)
" 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
' Tester knob indication: Voltage (()
Is the voltage OK?
YES Go to Step 2.
NO
• Loose or poor contacts on the ECM coupler
(terminal

5 or

B).
• Open or short circuit in the Red wire or B/Br
wire.
YES Go to Step 3.
NO
• Check the vacuum hose for crack or damage.
• Open or short circuit in the G/B wire.
(Front cylinder side)
• Open or short circuit in the G/Y wire.
(Rear cylinder side)
• If vacuum hose and wire are OK, replace the
IAP sensor with a new one.
1
V
2
V
SAMPLE