Suzuki SV650A - Page 29

28 SV650K7/SK7/AK7/SAK7 (’07-MODEL)
6) Measure the voltage at the Red wire

B and ground.
7) Also, measure the voltage at the Red wire

B and B/Br wire

C.
$ TP sensor input voltage: 4.5 – 5.5 V
(

+ Red –

- Ground)
(

+ Red –

- B/Br)
" 09900-25008: Multi-circuit tester set
' Tester knob indication: Voltage (()
Is the voltage OK?
Step 2
1) Turn the ignition switch ON.
2) Connect the test harness

1 between TP sensor and wire har-
ness.
3) Measure the TP sensor output voltage at the coupler
(between

+ P/W and

- B/Br) by turning the throttle grip.
$ TP sensor output voltage
Throttle valve is closed: Approx. 1.1 V
Throttle valve is opened: Approx. 4.3 V
" 09900-25008: Multi-circuit tester set
09900-28630: TPS test wire harness
' Tester knob indication: Voltage (()
Is the voltage OK?
YES Go to Step 2.
NO
• Loose or poor contacts on the ECM coupler
(terminal

5 or

B).
• Open or short circuit in the Red wire or B/Br
wire.
1
V
2
V
ECM
TPS
P/W
R
B/Br
2
YES
• R, B/Br or P/W wire open or shorted to ground,
or poor

5,

B or

K connection.
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
NO
• Reset the TP sensor position correctly.
• Replace the TP sensor with a new one.
ECM coupler (Harness side)
2
SAMPLE