33--33
3) Program : Thread Sensing Board Program
<Fig. 3.1.1-3> automatically appears when the operating program and data is installed either via FDD or USB.
This screen can be viewed when selecting ‘THREAD’ in <Fig. 3.0-3>.
To upgrade the thread sensing board program, press . Press to cancel.
[Fig. 3.1.1-3]
2) Data : It is needed by the embroidery operating program.
Use the direction keys , as in <Fig. 3.0-3> to move to ‘DATA’ and press . Then
<Fig. 3.1.1-2> appears.
To use a floppy diskette for installation, insert the floppy diskette containing the operating program and then
press . To use a USB memory for installation, insert the USB memory into the USB port, and then
press . To cancel installation, press .
To Next Page
Loading...
Need help?
General
