EasyManuals Logo

Swift Motorhome Owner's Handbook

Swift Motorhome
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
Equipment Details
37
MODEL RM4201
LP Gas Operation
1. Open the shut-off valve of the gas bottle
(check that there is enough gas). Open
any on-board shut-off valve.
2. Check that the switches for mains (B) and
12V (A) operation are OFF.
3. Turn the gas control (D) to position ‘max’.
4. Turn on the electric igniter (E). A ticking
sound will be heard and a lamp in the
switch will start flashing.
5. Depress the knob (D) of the flame failure
device.
6. When the lamp stops flashing the flame is
alight.
7. Keep the flame failure knob (D) depressed
for a further 10–15 seconds.
8. Check that the flame remains alight by
viewing through glass in the refrigerator.
9. To terminate gas operation, turn knob (D)
to the OFF position. Set switch (E) to OFF.
RM4201
A B C D E
MODEL RM4200 AND RM4262
Bottled Gas Operation - Lighting the
burner
1. Open the shut-off valve of the gas bottle
(check that there is enough gas). Open
any on-board shut-off valve.
2. Check that the switches for mains and
12V are off.
3. Depress and turn on the gas control
safety device knob (D) to the large flame
symbol.
4. Depress the gas control safety device
knob (D) and hold it down while
depressing the piezo-electric igniter
button (E) rapidly 3 or 4 times in quick
succession.
5. Check the flame viewer (located bottom
left of refrigerator) to see if the flame is
alight.
6. Keep the safety device control knob
depressed for a further 15–30 seconds.
Fig. A Control Panel - RM420 & RM4262
A B C D E
230V Operation
1. Turn off gas or 12V operation when
applicable.
2. Turn the knob (C) of the thermostat to its
highest (coldest) position.
3. Set switch (B) to position I.
12V Operation
Your refrigerator will only operate on 12V
when the engine of the vehicle is running.
1. If applicable, turn off the gas operation.
2. Set the 12V rocker switch (A) to I.
WARNING:
When in transit, your refrigerator should be
run on 12V and NOT on gas.
Regulating the Temperature
It will take a few hours for the refrigerator to
reach normal operating temperature, so it is
suggested that the refrigerator be started
well in advance of a journey and, if possible,
to store it with pre-cooled foodstuffs.
On 230V operation the refrigerator is
controlled by a thermostat knob (C) and this
should be set at 3–5. If a lower (colder)
temperature is desired, set the thermostat to
a higher figure.
On 12V operation the refrigerator works
continuously.
LP gas operation should always be initiated
with the knob (D) at the ‘max’ position. Once
the refrigerator is running, the temperature
is controlled by turning the control knob
between ‘max’, ‘mid’ and ‘min’ settings -
‘max’ being the coldest temperature.

Table of Contents

Other manuals for Swift Motorhome

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Swift Motorhome and is the answer not in the manual?

Swift Motorhome Specifications

General IconGeneral
BrandSwift
ModelMotorhome
CategoryMotorhomes
LanguageEnglish

Related product manuals