EasyManuals Logo

Swift Motorhome Owner's Handbook

Swift Motorhome
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
Equipment Details
42
5. The ambient temperature is too high.
6. Too much food is loaded at one time.
7. The door is not properly closed or the
magnetic sealing strip is defective.
If the refrigerator still does not work
properly, call a service technician.
MODEL RM4291 (86 litres)
Two rocker switches are used to select the
electric power supply, one for 12V (A) and
one for 230V (B) (see Fig. C).
Refrigerator temperature is controlled by a
thermostat knob (C) when the refrigerator
runs on 230V.
The refrigerator runs continuously on 12V
operation (no thermostat).
The gas supply is turned ON/OFF by means
of the knob (D). When lighting the gas, the
knob must be pressed as explained in LP
Gas Operation.
Refrigerator temperature is controlled by a
thermostat (D) when the refrigerator runs on
LP gas.
The gas flame is electronically lit, monitored
and re-lit if necessary. For this, the toggle
switch (E) should be ‘ON’ during gas
operation.
The RM4291 is fitted with an internal light
which is operated by the door.
STARTING THE REFRIGERATOR
LP Gas Operation
Before you start gas operation:
1. Open the shut-off valve of the gas bottle
(check that there is enough gas). Open
any on-board shut-off valve.
2. Check that the switches for mains and
12V operation are OFF.
3. Turn on gas supply by pressing knob (D)
and turning it to the highest flame
position.
4. Press ON switch (E). A light in the switch
should now start to flash, indicating that
sparks are being generated at the burner.
5. When the flame ignites, the sparking
stops automatically and the switch stops
flashing.
6. Keep the knob (D) pressed for a further
10 to 15 seconds to activate the flame
failure device, then release it.
7. To terminate gas operation turn knob (D)
to the ‘•’ position and put switch (E) to
the OFF position.
230V Operation
1. Turn off gas or 12V operation when
applicable.
2. Turn the knob (C) of the thermostat to its
highest (coldest) position.
3. Set switch (B) to position I. The switch
will light up green when the power supply
is connected.
12V Operation
Your refrigerator will only operate on 12V
when the engine of the vehicle is running.
1. If applicable turn off the gas operation.
2. Set the 12V rocker switch (A) to I. The
switch will light up red when the power
supply is connected.
REGULATING THE TEMPERATURE
The position numbers refer to Fig. A.
Once the refrigerator has been started it will
take a few hours to become cold.
On 230V operation the refrigerator is
controlled by a thermostat and the
thermostat knob (C) should be set at 3-5.
Fig. C Control Panel - RM4291
C D E
A
B F

Table of Contents

Other manuals for Swift Motorhome

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Swift Motorhome and is the answer not in the manual?

Swift Motorhome Specifications

General IconGeneral
BrandSwift
ModelMotorhome
CategoryMotorhomes
LanguageEnglish

Related product manuals