Equipment Details
38
12V Operation
Your refrigerator will only operate on 12V
when the engine of the vehicle is running.
1. If applicable, turn off the gas operation.
2. Set the 230V rocker switch (B) to ‘O’ and
the 12V rocker switch (A) to 1.
WARNING:
When in transit, your refrigerator should be
run on 12V and NOT on gas.
Regulating the temperature
Once the refrigerator has been started it will
take a few hours to become cold.
On 230V operation the refrigerator is
controlled by a thermostat and the
thermostat knob (C) should be set at 3. If a
colder temperature is required, set the
thermostat to a higher number and vice
versa.
On 12V operation the refrigerator works
continuously.
On LP gas operation the refrigerator
temperature is regulated by the gas control
knob (D). If the ambient temperature is above
25°C and/or the door of the refrigerator is
frequently opened, the knob should be set in
the ‘max’ position. Below 25°C, the knob
should be set at ‘mid’ and below 10°C at
‘min’ to avoid temperatures below freezing in
the main compartment.
MODEL RM6401 AND RM6291
The refrigerator is equipped to operate off
mains power, 12V or liquid gas. The desired
potion is selected by means of energy
selector switch (A). Energy selector switch
(A) has four settings: AC mains power, DC
(12V), gas (liquid gas), O off.
Refrigerator temperature is controlled by a
thermostat (B) when the fridge runs on gas
and mains electric. No thermostat control is
available on 12V operation.
(C) is the automatic ignition indicator.
7. Release the safety device control knob
and again check to see that the flame is
alight.
8. To terminate gas operation, turn knob (D)
to ‘O’.
ELECTRIC OPERATION
230V Operation
1. Turn off gas or 12V operation when
applicable.
2. Turn the knob (C) of the thermostat to its
highest (coldest) position.
3. Set switch (B) to position I.
Flame Viewing Glass
To Next Page
Loading...
Need help?
General
