EasyManuals Logo

Swift Motorhome Owner's Handbook

Swift Motorhome
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
Equipment Details
59
6. Before returning product or parts, they
should be cleaned in order to carry out
inspection and repair.
7. No other warranty is given and no
personal representative is authorised to
make any warranty or assume liability by
words or action under any warranty other
than that is contained herein. This
warranty is expressly in lieu of any other
expressed or implied warranty of
whatever nature and expressly excludes
any other or further liability.
HEATING
TRUMATIC E 2400
L.P.G. Heater with electronic control, built-
in air distribution and thermostat
OPERATING INSTRUCTIONS
Always observe the operating instructions
and "Important operating notes" prior to
starting! The vehicle owner is responsible for
the correct operation of the appliance.
Switching on the Heating
1. Remove cowl cap.
2. Turn on gas cylinder and open quick-
acting valve in the gas supply line.
3. Adjust desired room temperature at rotary
knob.
4. Switch the slide valve (a) to heating and
the slide valve (b) to the desired output
setting. If the outside temperature is low,
switch to high setting.
Note: The Trumatic E heater has been tested
and approved for operation, also when the
vehicle is moving. The burner with fan
assistance guarantees satisfactory operation,
even under extremely windy conditions. It
may be necessary to observe respective,
country-specific regulations for the operation
of liquid gas appliances when the vehicle is
moving.
Switching on the Ventilation
Switch the slide valve (a) to ventilation switch
and the slide valve (b) to high setting or low
load.
Switching off
Move the slide valve (a) to middle position.
If the appliance is switched off after a heating
phase, the fan can continue running in order
to make use of the residual heat.
If the appliance is not used for a prolonged
period of time, mount the cowl cap, close
quick-acting valve in the gas supply line and
turn off gas cylinder.
Green indicator lamp "Operation"
(under rotary control knob)
When the appliance is switched on (heating
or ventilation) the green indicator lamp must
be illuminated (the fan is running). If the
indicator lamp is not illuminated, possibly
check the (main) switch. For this purpose
observe respective instructions of the vehicle
manufacturer.
During the heating operation, while the flame
is burning the green indicator lamp lights up
twice the intensity. This also makes it
possible to determine the instantaneous
switching point of the room temperature.
b a
a = Slide valve
Heating - Off - Ventilation
b = Slide valve for high setting (large
flame symbol) and low setting
(small flame symbol)
b a
b a
b a
Control Panel with Thermostat

Table of Contents

Other manuals for Swift Motorhome

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Swift Motorhome and is the answer not in the manual?

Swift Motorhome Specifications

General IconGeneral
BrandSwift
ModelMotorhome
CategoryMotorhomes
LanguageEnglish

Related product manuals