Sym MaxSym 600i ABS - Page 181

12. Cooling System
12-10
4:
Check the air exhausted through the thermostat
tube head until coolant come out.
5:
Check the air exhausted through the thermostat
cover joint until coolant come out.
6:
Reconnect thermostat tube(19320) to thermostat
cover joint(19315)
7:
Loosen flange bolt ( 8X12) on the water pump
cover(19221) for exhausting air until coolant
come out.
Tighten the flange bolt when finish.
Thermostat tube head
Thermostat cover joint end
Reconnect thermostat tube
Air evacuating bolt
To this chapter contents