EasyManua.ls Logo

Sym Wolf Classic 150 - USE OF EACH COMPONENT; Gauges; Operation of Ignition switch; Use of buttons

Sym Wolf Classic 150
35 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7. Use of each component
8
GAUGES
CAUTION:
Do not wipe plastic components, e.g. instrument panel, headlight, with organic solvents such as
gasoline…etc to avoid damaging these components.
Speedometer:
This shows your speed in miles per hour (outer-mph) and in kilometer per hour (km/h-inner).
# Odometer:
Indicates total accumulated distance traveled.
The measurement unit of odometer for U.S. model (PA15C1-A) is mile.
The measurement unit of odometer for Canadian model (PA15C1-C) is kilometer.
! Trip odometer :
The rider can measure the trip odometers. It shows four digits; 3 in kilometers and 1 in hundred meter.
(The trip odometer will return to zero if its measurement is over 1000 kilometers or turn the reset knob.)
! Fuel gauge:
The pointer in this gauge shows how much fuel remains in the tank.
The pointer stays in “E” position when key switch is turned to “OFF.”
When key switch is turned to “ON”, and the “pointer” also in “E” position (red area). Refuel immediately.
! High Beam Indicator:
This indicator comes on with high beam headlight is turned on.
! Turn Signal Indicator:
The left or right Indicator will be flashing according to the operated directions of turn signal light switch
when it is turned on.
! Transmission neutral Indicator:
This indicator show transmission neutral.
! Tachometer:
Rotational speed of the engine.
Trip odometer
High Beam
Indicator
Odometer
Turn Signal Indicator
Transmission neutral
Indicator
Trip odometer
reset knob
Fuel gauge
tachometer
Trip odometer

Table of Contents