Sym Wolf Classic 150 - Riding in Grade; Transmission Operation; Correct Riding

9.Riding the motorcycle
16
RIDING IN GRADE
Up Grade
Riding up a slightly grade can ride with high position gear.
Under heavy loading or steep grade riding condition, It must
ride with low gear.
Down Grade
Close the throttle and operate the brakes when riding down a
slight grade. Shift the gear to low gear in case of heavy
loading or riding down steep grade condition.
CAUTION:
!
Braking apply both the front and rear brakes.
TRANSMISSION OPERATION
! The change pedal is located on the left side of the engine.
Shift transmission to the lower gear when driving hard or
down grade.
! Squeeze the clutch lever fully, operate change pedal to the
proper position, then release the clutch lever to make a
gear change.
! Don’t operate the transmission when the engine is not
running.
! Don’t operate change pedal rudely, or the transmission will
be damaged.
! Shift the gear to the next lower position for overtaking other
vehicles.
This limit speed for shift to lower gear.
5
th
→ 4
th
Below 80km/h
4
th
→ 3
rd
Below 70km/h
3
rd
→ 2
nd
Below 50km/h
2
nd
→ 1
st
Below 25km/h
CORRECT RIDING
Optimum Start Riding
! Turn on the turn signal and make sure of no
vehicle coming behind before start riding.
1
N
2
3
4
5