Sym Wolf Classic 150 - Rear Shock Absorber Adjustment; Brake

7. Use of each component
12
REAR SHOCK ABSORBER ADJUSTMENT
! There are five positions in each shock absorber can be
adjusted.
! I: normal position. (light rode or good road condition)
! II~V: increase the spring tension gradually.
Method of adjustment：heavier load or worse road
condition)
! Pull up the shock absorber spring, adjust the adjuster.
CAUTION:
!
The left and right absorbers must be adjusted with
the same position.
BRAKE
! Avoid unnecessary sudden braking.
! Use front and rear wheel brakes simultaneously when braking.
! Avoid brake continuously for a long period of time because that may overheat the brakes and reduce
its braking efficiency.
! Slow down and brake early when riding in rainy days on slippery roads. Never apply the brakes
suddenly to prevent skidding and falling.
! Using only the front brake or the rear brake increases the risk of falling because the motorcycle is tend
to pulled to one side.
《Engine Brake》
Return the throttle valve handle back to its original position, and apply engine brake.
It is necessary to apply both brake and engine brake intermittently when riding on a long or stiff slope.
For Rear Wheel
For Front Wheel
I
II
III
IV
V
Soft→Hard
Adjuster