OPERATION OF IGNITION SWITCH
“Start” position
! Engine can be started in this position.
! Ignition switch key can not be removed.
“Stop” position
! Engine is shut off and can not be started in this
position .
! Ignition switch key can be removed.
CAUTION:
! Never operate the ignition switch key when the motorcycle is running. To turn the ignition
switch to “OFF”, will shut off the electrical system and that may result in a dangerous accident.
Therefore, the ignition switch can only be turned off after the motorcycle has been completely
stopped.
! Always remove the key and be sure to take the key away with you after locking the steering
handle before leaving your motorcycle.
!
If ignition switch remains in the “ON” position for a prolonged period after the engine has been
stopped, the battery’s capacity will be reduced and this may affect the engine’s start ability. .
STEERING HANDLE LOCK
The steering handle lock is located on the steering stem
directly below the steering head.
! Turn the steering handle fully to the left
! Insert the ignition switch key into the lock
! Turn the key clockwise, then the steering handle can be
locked.
! Remove the Ignition switch key.
! When unlocking, simply turn the key anti-clockwise.
NOTE:
! For preventing the vehicle to be stolen, lock the
handle bar when parked.
! After locked, turn of the handle bar left and right to
make sure it.
!
When leaving the vehicle, remember to remove the
key.
To Next Page
Loading...
