10. Cooling System
Coolant change
10-5
Warning
● Never attempt to carry out service work on the
cooling system unless the engine is
completely cooled down, otherwise, you may
get scalded.
Remove right-front body cover. (screwX2)
Remove radiator tank cap.
Remove under spoiler. (boltX4)
Place a water pan under the water pump;
loosen the drain bolt to drain out the coolant.
Reinstall the drain bolt.
Refill system with coolant and bleed the air
bubbles.
● Remove radiator tank cap.
● Start the engine and confirm no bubbles from
the radiator and the coolant level is stable.
● Shut down engine, refill coolant if necessary.
Caution
● To avoid the water tank rusting, please do
not use an unknown trademark refrigerant.
Coolant recommended: SYM Bramax radiator
agent.
Concentration: 50%
Reserve tank check
● Remove left-front body cover.
● Check reserve tank coolant level, refill coolant to
standard level. (between upper and lower)
● Install reserve tank cap.
Caution
● Do not fill too much coolant, or the collant
will backflow after the water temperature
rises.
drain bolt
Radiator tank cap
Reserve tank cap
To Next Page
Loading...
Need help?
General
