■ Logs VXLogView JobID job_id
Use to display debug information for a specific job ID.
■ Logs VXLogView Minutes minutes_ago
Use to display debug information for a specific timeframe.
■ Logs VXLogView Module module_name
Use to display debug information for a specific module. The available module
names are: All, CallHome, Checkpoint, Common, Config, Database,
Hardware, HWMonitor, Network, RAID, Seeding, SelfTest, Storage,
SWUpdate, Commands, CrossHost, and Trace.
2
If you want, you can copy the unified logs with the Main > Support > Share
Open command. Use the desktop to map, share, and copy the logs.
Note: The NetBackup Appliance unified logs are not the same as the NetBackup
unified logs, such as nbpem or nbjm. NetBackup Appliance has its own set of unified
logs. To collect the NetBackup unified logs, use the Collect Logs Wizard and select
NetBackup.
See “Troubleshooting and tuning Appliance from the Appliance Diagnostics Center”
on page 31.
You can also use the Main_Menu > Support > Logs commands to do the following:
■ Upload the log files to Symantec Technical Support.
■ Set log levels.
■ Export or remove CIFS and NFS shares.
Note: The NetBackup Appliance VxUL logs are no longer archived by a cron job,
or a scheduled task. In addition, log recycling has been enabled, and the default
number of log files has been set to 50.
Refer to the NetBackup Appliance Command Reference Guide for more information
on the above commands.
See “About working with log files” on page 48.
52Working with log files
Viewing log files using the Support command
To Next Page
Loading...
