Troubleshooting generic
issues
This chapter includes the following topics:
■ Troubleshooting generic issues
■ Troubleshooting target mode port from the client
■ Troubleshooting failure to connect to a media server and create storage unit
■ Troubleshooting possible issues to enable or disable the SAN Client Fibre
Transport
■ Troubleshooting self-test errors
■ About troubleshooting a corrupt storage partition
■ About troubleshooting FactoryReset problems
■ Discard RAID preserved cache after performing a factory reset
■ Crash analysis in case of kernel coredump
■ Troubleshooting IPv6 network problems
■ Reinstallation of the NetBackup Appliance software on a 5220 can fail
■ NetBackup deduplication disk pool or disk volume intermittently goes to a DOWN
state
■ Failed to perform the Appliance Factory Reset operation on a media server
■ Failed to boot NetBackup 5220 appliance due to the missing embedded RAID
controller information
■ Resolving an fsck test failure
7
Chapter
To Next Page
Loading...
