Symantec netbackup 5030 - Page 58

To enable VxMS logging
1
From the Support > Logs view of the NetBackup Appliance Shell Menu, run
the following command:
SetLevel VxMS 1
2
Verify that VxMS logging has been enabled with the GetLevel command. If
the VxMS logs are enabled, the GetLevel command output displays the
following:
VxMS debug level is TRC_TOP|PARAM_IN|PARAM_OUT|DEBUG|PARAM_FULL
To disable VxMS logging
1
From the Support > Logs view of the NetBackup Appliance Shell Menu, run
the following command:
SetLevel VxMS 0
2
Verify that VxMS logging has been disabled with the GetLevel command. If
the VxMS logs are disabled, the GetLevel command output displays the
following:
VxMS debug level is disabled
See “About working with log files” on page 48.
58Working with log files
Enabling and disabling VxMS logging