5-158
LS 5700/LS 5800 Product Reference Guide
Custom Tailoring
Time-out Between Decodes, Same Symbol
This parameter sets the minimum time between decodes
of the same symbol. It is programmable in 0.1 second
increments from 0.0 to 9.9 seconds. (Setting this above 0.4
seconds is recommended.)
Scan the bar code below to select a new time-out. Next scan
two numeric bar codes on pages 5-246 to 5-255, the first
representing seconds, the second tenths of seconds. If you
make an error, or wish to change your selection, scan
CANCEL on page 5-256.
TIME-OUT BETWEEN SAME SYMBOL
To Next Page
