2-20
LS 5700/LS 5800 Product Reference Guide
Beeper
The scanner has an internal beeper to signal a good decode
or provide other information (see Beeper Definitions
beginning on page 4-8). An external beeper can also be
connected to the RS-232C port. Either or both of these
beepers can be enabled or disabled through the use of bar
code menus.
LS 5700 Controls
See Figure 2-16 on the following page. The LS 5700 has a
push button near the top right corner. This push button is
to adjust both the volume and tone of the beeper, and to
wake the scanner from its Rest or Sleep mode.
When the scanner is operating, depress this button to adjust
the volume/tone. Hold down the button until the desired
sound is obtained. There are five distinct volume/tone
combinations. Each combination beeps two times before
cycling to the next sound. When you hear the volume/tone
combination you want, immediately release the button.
If the scanner is in a Rest or Sleep mode, depressing this
push button briefly will awaken the scanner.
To Next Page
Loading...
