3-4
LS 5700/LS 5800 Product Reference Guide
Programming
You can custom tailor the performance and operation of the
scanner with a series of bar codes. Refer to the Default Table
beginning on page 5-6 for a list of the factory-
programmed defaults. A table of Beeper Definitions
applicable to programming is located on page 4-8.
Scanning Sequence Examples
In most cases you need only scan one bar code to set a
specific parameter. For example, if you want to set the baud
rate to 9600, simply scan the 9600 bar code listed under
BAUD RATE. The scanner issues a warble tone, signifying
a successful parameter entry.
If you want to enable or disable prefixes and suffixes, or
customize the data transmission format, you have to scan
several bar codes.
Errors While Scanning
Don’t worry if you make an error during a scanning
sequence. Merely scan CANCEL and reenter the correct
parameter.
To Next Page
