Chapter 1 Getting Started
Using Commands to Control Key Functions (Examples)
1-24 Getting Started Guide
Set the latitude, longitude, and height parameters to represent the
latitude (in degrees, minutes, seconds), longitude (in degrees, minutes,
seconds), and altitude in meters above the GPS ellipsoid for the
58503B (altitude in meters above mean sea level (MSL) for the
59551A). (Note: if you know the position to this accuracy, the desired
position is of the antenna rather than the Receiver.)
NOTE For faster acquisition following repair, or power failure you may want
to write down the position after the Receiver has completed its survey.
To Next Page
Loading...
Need help?
General
