Chapter 3 Using Option 001 Front-Panel Display/Keypad (58503B Only)
Capabilities Under Special Circumstances
3-6 Getting Started Guide
To Access the DEMO MODE to Demonstrate
Front-Panel Capabilities
Access the product’s DEMO MODE using the following procedure.
1 Apply power to the 58503B. While the letters “HP” are moving from
right to left (about 2 seconds), press the Shift key.
If necessary, you can remove and re-connect power to re-initiate the
startup and try again. When you succeed, the product will enter its
DEMO MODE.
The DEMO MODE does not require an antenna connection. DEMO
MODE was designed to support the user during demonstrations,
during installation, and during initial connection to a PC.
The DEMO MODE responds to keypresses by displaying simulated
data for UTC Time, Longitude, Latitude, Altitude, Satellite Count, and
Status. These values are not related to the actual values, they are a
simulation.
2 To exit the DEMO MODE, press the Shift key and then press the
Alt key.
To Check Serial Port Settings During Installation
To display Serial Port settings during initial installation, press the
Serial Port key.
To Next Page
Loading...
Need help?
General
