operation
53
SYNRAD OEM v40 Operator’s Manual Version 4
Initial start-up
5
Remove the PWM Command signal from the User I/O connector. The LASE indicator on the laser
should turn o.
6
Place Firestar’s Shutter Switch (if equipped) in the Closed position.
7
On water-cooled v40 lasers, shut o the chiller or otherwise stop coolant ow through the laser.
Caution
possible
equipment
damage
Do not ow coolant through the laser for an extended period of time
when the laser is shutdown. This causes condensation to form inside
the laser which may result in catastrophic damage to internal optics
and electronic circuits.
If your Firestar v40 laser fails to lase, refer to Troubleshooting in the Maintenance/Troubleshooting chapter
for troubleshooting information.
To Next Page
Loading...
Need help?
General
