USB-CANmodul
6
SYS TEC electronic GmbH 2001 L-487e_6
The USB-CANmodul consists of a powerful microcontroller with
USB interface (Anchor Chips AN2131QC) and a CAN controller
(Philips SJA1000) which transmits and receives the CAN message.
Power for the USB-CANmodul is supplied through either the CAN
network or the USB bus. The module has two LEDs, one for status
display and one for power. Its small size (120x60x30mm) makes it
easily transportable.
Drivers for Windows 98 and 2000 are provided for the USB-
CANmodul. The USB configuration tool for Windows enables
connectivity and management of more than one device on the USB
bus. This USB network is configured using device numbers which
are assigned by the user and are stored in an EEPROM. The
functions for data exchange with the USB-CAN application are
available through a DLL (Dynamic Linked Library). The enclosed
demo program shows the easy handling of the DLL functions.
A host-PC with USB interface (Universal Serial Bus) is required.
You can find this USB interface on most newer IBM compatible PCs.
The operating systems MS-Windows 98 and 2000 support the USB
interface.
Contents of the Kit
•
Completely tested device
•
Systems Manual
•
Software (Tools, Demos, Windows system software)
•
USB cable (type A to type B; 1.5m)
To Next Page
Loading...