SYSMEX SA-90 - Supported Sample Tubes and Sample Racks

Chapter 6 Instrument Specifications
SA-90 Instructions for Use
30/
46
6.2 Supported sample tubes and sample racks
6.2.1 Supported sample tubes
The conditions of sample tubes that can be used in this instrument are as follows:
• Inner diameter: at least 8 mm
• Outer diameter: 10 to 15 mm
• Length: 100 mm or less (uncapped)
Sample tubes with an inside diameter of less than 9.4 mm cannot be mixed in the sample rack.
A tube holder is preinstalled in sample racks and urgent sample holders. Replace it with the appropriate holder
as necessary.
6.2.2 Supported sample racks
Sample racks that can be used with the instrument are AB842714/Rack No. 262.
Sample rack holders are indicated below:.
For details, see the CN-3000, CN-6000, CN-3500 or CN-6500 "Instructions for Use".
(³CN-3000 and CN-6000 Instructions for Use, "Chapter 11: 11.4.2 Usable sample tubes")
(³CN-3500 and CN-6500 Instructions for Use, "Chapter 11: 11.5.2 Usable sample tubes")
Part number Item name
CM751573 Adapter No. 237
AJ860087 Adapter No. 238
36617919 Holding Material No. 59
CC926688 Support No. 1123