EasyManua.ls Logo

Systema K21 - Instructions for the User

Systema K21
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
Rev. 12GB0712
SYSTEMA S.p.A.
AIRTIGHT GAS CONVECTORS
4 INSTRUCTIONS FOR THE USER
4.1 General rules
This Manual is an integral and essential part of this devi-
ce and must be carefully stored in its vicinity for purpo-
ses of rapid consultation.
Read the instructions and warnings provided herein
carefully because they provide important information
regarding safety, installation, use and maintenance.
The device must be started for the first time by qualified
personnel only.
Immediately switch off the device whenever it stops
and/or malfunctions. All repairs must be performed by
qualified personnel using original spare parts only.
Failure to observe the above can compromise operatio-
nal safety.
Scrupulously respect the indications provided by the
Manufacturer and have the device serviced by qualified
personnel (at least once a year) to guarantee satisfac-
tory operation.
Delicate surfaces such as curtains, furniture, and woo-
den or plastic chairs must be kept at a minimum distan-
ce of 30 cm from the device.
Provide extra protection against the risk of burning by
the contact of children, the elderly or disabled with the
hot surfaces of the shell wherever necessary. Such addi-
tional protection must not obstruct the passage of hot air
and the irradiation of heat from the front panel.
4.2 Warranty
4.2.1 Object and duration of the gua-
rantee
1) The Guarantee is limited to defects in the material or
manufacturing of the components supplied by
SYSTEMA. In the case of material or manufacturing
defects, SYSTEMA shall repair or replace the faulty
parts free of charge ex works; ANY OTHER FORM
OF GUARANTEE OR COMPENSATION, BOTH
LEGAL AND CONVENTIONAL, IS EXPRESSLY
EXCLUDED. The replaced parts shall be promptly
returned to SYSTEMA, carriage paid to the works at
S. Giustina in Colle (PD) at the user’s expense. If
work is carried out under guarantee, the user shall
be charged a flat rate, as well as a distance refund
if the place of intervention is more than ten kilome-
tres from the S.C. (Service Centre).
2) The validity of the Guarantee runs from
“Commissioning”, on condition that this takes place
within 6 (six) months of the date of purchase of the
appliance by the user. In any case the Guarantee
expires 18 (eighteen) months from the date of the
SYSTEMA invoice.
3) Any replacement of faulty parts (or of the whole
appliance) shall not prolong the original expiry term
of the Guarantee. The Guarantee on the replaced
parts shall cease with the expiry date of the
Guarantee on the Appliance.
4) The “duration of the guarantee” shall be 1 (one) year
on each component of the appliance.
4.2.2 Exclusions from the guarantee
1) The Guarantee is not operative in the following cases:
a) Faults that cannot be attributed to defects in the
material or manufacture, without limitation:
- breakages that occurred during transport;
- non conformity of the plant with the laws and the
local regulations in force;
- failure to respect the installation specifications given
in the technical notes accompanying the appliance
and/or of good technical practice;
- damage caused by accidents, fire, general acci-
dents or negligence that cannot be attributed to
SYSTEMA.
b) Tampering or faults due to interventions of non
authorised personnel.
c) Defects caused by malfunctions depending on the
electric power supply mains or on fuel.
d) Faults due to: bad maintenance, neglect or improper
use, variations in voltage in the power supply, humi-
dity and dust in the premises, errors in dimensions
and/or faulty performance of installation.
e) Corrosion or breakages caused by: stray current,
condensation, overheating caused by incorrect
regulation of the gas pressure in the supply or in the
burner, or the use of gas fuel with different heating
characteristics from those on the data plate.
f) Use of non original spare parts or parts not authori-
sed by SYSTEMA.
g) Normal wear and tear.
h) Products that have been incorrectly kept or stored.
2) The Guarantee is not operative in the following cases:
a) Payment of the appliance has not been carried out
within the terms contemplated in the contract.
b) If “Commissioning” has not been performed by the
S.C. and/or a copy of the respective Guarantee
Certificate, duly compiled in all parts and signed,

Related product manuals