5
Rev. 12GB0712
SYSTEMA S.p.A.
AIRTIGHT GAS CONVECTORS
1 GENERAL RULES
This Manual is an integral and essential part of this devi-
ce and must be carefully stored in its vicinity for purpo-
ses of rapid consultation.
Read the instructions and warnings provided herein
carefully because they provide important information
regarding safety, installation, use and maintenance.
Installation must be performed exclusively by qualified
professional personnel in complete respect of the safety
regulations in force. The Manufacturer declines all liabi-
lity for damages caused by the erroneous installation or
incorrect and/or inappropriate use of the device.
Keep all potentially dangerous packaging elements
(nylon, polystyrene foam, wood, staples, etc.) far from
the reach of children.
The device must be started for the first time by qualified
personnel only.
Immediately switch off the device whenever it stops
and/or malfunctions. All repairs must be performed by
qualified personnel using original spare parts only.
Failure to observe the above can compromise operatio-
nal safety.
Scrupulously respect the indications provided by the
Manufacture to guarantee satisfactory operation.
Never leave clothes, paper or other objects that might
obstruct the passage of hot air from the slots on top of
the radiator.
Delicate surfaces such as curtains, furniture, and woo-
den or plastic chairs must be kept at a minimum distan-
ce of 30 cm from the device.
Provide extra protection against the risk of burning by
contact of children, the elderly or disabled with the hot
surfaces of the shell wherever necessary. Such additio-
nal protection must not obstruct the passage of hot air
and the irradiation of heat from the front panel.
2 GENERAL TECHNICAL CHARACTERISTICS
2.1 Device classification
Device type: Type C11 (natural draught) and C13 (for-
ced draught) depending on the flue gas suction and
expulsion system used.
Device output class: 1
2.2 Packing list and check on
incoming material
a) The device is delivered complete with all its parts in
a box that also contains a set of wall attachment
screws.
b) The air/flue gas terminals and the grille are packed
separately.
To Next Page
Loading...
