Portbase User Guide
set “line <Line Type>”
Portbase supports two types of network connection types (IP and DHCP).
Set IP type: set “line IP”
Set DHCP type :
set “line dhcp”
Set PPPoE type : set “line pppoe”
set “ip <IP Address>”
Set IP address of Portbase.
(This command only works when Line Type is set to IP.)
set “mask <Subnet Mask>”
Set subnet mask address of Portbase.
(This command only works when Line Type is set to IP)
set “gateway <Gateway Address>”
Set Gateway address.
(This command only works when Line Type is set to IP)
set “snmp <Enable/Disable>”
When standard SNMP server manages Portbase,
determine if SNMP Agent service will be used or not.
set “nms <Portview IP Address>”
When Portbase management software Portview is used,
set server IP address on which Portview is installed.
(Refer to
Chapter 5. Management with Portview for further information.)
set “name <Portbase Name>”
Set the name for Portbase. 32 Characters at maximum. (Default: None)
set “group <Group Name>”
Set the group name for Portbase. 32 Characters at maximum. (Default: None)
set “location <Location Name>”
Set the location name for Portbase. 32 Characters at maximum. (Default: None)
46
To Next Page
Loading...