Press NEXT key,
4: Press Next when stable
Wait for to display stable indication and
Press NEXT key,
Display will be show Calibration Finished
If its show, FAIL, Please Start again
Please check the internal counts (section 5.2.5.2)
if the counts is increasing correctly, when pressing the pan, do the calibration again.
Next Cal Reminder
If want to remind next calibration date, click the
cal reminder box for to enable next cal date
option. It will remind when its reach due date
while initial start up.
Press End key to exit from the calibration mode.
5.2.5.2. Internal Counts
The AD internal counts will be displayed. If load
cell is connected and working correctly,
When you place goods on the pan, counts will be
increase accordingly.
Press << key at the top of the left corner for to go
back to last step , or press other options to go to
next step.
To Next Page
Loading...
Need help?
General
