5.2.3. Weighing settings
5.2.3.1. Approval setting
It can select weighing settings to None Approval /
OIML Approval
Press < key at the top of the left corner for to go
back to last step, or press other options to go to
next step.
Note: If selected OIML, weighing setting functions can’t access.
If want to access weighing settings, press CAL switch for to access. CAL switch is locating
bottom of the housing.
5.2.3.2. Range Mode
Range mode. Can select signal range, dual
interval, dual range.
Press < key at the top of the left corner for to go
back to last step, or press other options to go to
next step
5.2.3.3. Decimal point
Select desired decimal digits from the list
Press << key at the top of the left corner for to go
back to last step, or press other options to go to
next step
To Next Page
Loading...
Need help?
General
