Multitone Paging Interface Fitting Instruction 15
© Tait Electronics Limited July 2008
1.7 Set-up Tx Channel Configuration
1. Program the radio using the front panel RJ45 (PROG/MIC)
programming port and the TX/RX switched to Tx.
2. In the PGM Specifications form select the band that is being built.
3. In the Channels form set up the channels as required.
Note Note: frequency will change according to the radio band, e.g. H5,
6,7 will be 460.1MHz and B1 will be 160.1MHz. (25kHz band-
width, country squelch for all)
1.8 Set-up Programmable Audio I/O
1. On the Programmable I/O form in the Audio tab set as per the fol-
lowing table.
1.9 Set-up Programmable Digital I/O
1. On the Programmable I/O form in the Digital tab set as per the fol-
lowing table.
Rx/PTT Type Tap In Tap In Type
Tap In
Unmute
Tap Out Tap Out Type
Tap Out
Unmute
Rx None A-Bypass In On PTT None D-Split On PTT
Mic PTT None A-Bypass In On PTT None C-Bypass Out On PTT
EPTT1 T12 A-Bypass In On PTT None C-Bypass Out On PTT
EPTT2 None A-Bypass In On PTT None C-Bypass Out On PTT
Pin Direction Label Action Active Debounce
Signal
State
Mirrored
To
AUX_GPI1 Input RT_DI_1 BCD Pin 0 Low 10 None None
AUX_GPI2 Input RT_DI_2 BCD Pin 1 Low 10 None None
AUX_GPI3 Input RT_DI_3 External PTT 2 Low 10 None None
AUX_GPIO4 Output HI_VSWR F2 Key Status High None Momentary None
AUX_GPIO5 Output OOL F3 Key Status High None Momentary None
AUX_GPIO6 Output HI_TEMP F4 Key Status High None Momentary None
AUX_GPIO7 Input TXKEY External PTT 1 Low 2 None None
IOP_GPIO1 None PIN_9 No Action High None None None
IOP_GPIO2 None PIN_10 No Action High None None None
IOP_GPIO3 None PIN_11 No Action High None None None
IOP_GPIO4 None PIN_12 No Action High None None None
IOP_GPIO5 None PIN_13 No Action High None None None
IOP_GPIO6 None PIN_14 No Action High None None None
IOP_GPIO7 None PIN_15 No Action High None None None
CH_GPIO1 None C_HEAD No Action High None None None
To Next Page
Loading...
Need help?
General
