Tait tm8200 User Guide

30 Operating in conventional mode
3 Press Select.
While monitor is on, the green
LED flashes continually and the
monitor icon appears in
the icon bar.
Making a call
1 Select the required channel or scan group.
2 Check that the channel is clear. If the green LED is glowing,
the channel is busy and you may not be able to transmit.
3 Once the channel is clear (the green LED is off), lift the
microphone off the microphone clip.
4 Hold the microphone about 5cm (2 inches) from your
mouth and press the PTT key to transmit.
5 Speak clearly into the microphone and release the PTT
key when you have finished talking.
While you are transmitting, the
red LED glows and the transmit
icon appears in the icon bar.
Transmit timer
Your radio may have a transmit timer that limits the amount
of time you can transmit continuously.
When the transmit timer is about to
expire, the message Transmit
timeout imminent appears in the
display, the red LED flashes and the
radio gives three beeps.
You must release the PTT before you can transmit again.
Note: Your radio may be unable to transmit for a short time
after the transmit timer has expired.

Tait tm8200 Specifications

General

Operating Temperature Range	-30°C to +60°C
IP Rating	IP54
Channel Spacing	12.5 kHz, 25 kHz
Battery Life	N/A (Mobile Radio)
Frequency Range	136-174 MHz, 400-470 MHz