5-23
MAINTENANCE
AFTER THE INITIAL 50 HOURS (ONLY FOR NEW MACHINES)
7. Turn the filter (5) counterclockwise with the
filter wrench and remove it.
8. Clean the surface of installation of the filter
stand.
9. Apply a thin layer of oil on the packing of
the new filter.
10. Install the new filter by hand.
11. Securely tighten the filter by hand (not
using the filter wrench) after its packing
comes in contact with the surface of
installation.
12. Add oil up to between the upper limit (H)
and the lower limit (L) of the dipstick (1).
Problems could arise if the oil level is
either too low or too high.
13. Tighten the oil filler cap (2).
14. Start the engine, run it at low idle for
about 5 minutes, then stop it.
15. After about 10 minutes, inspect the oil
level.
16. Install the under cover (3).
To Next Page
Loading...
Need help?
General
