3-3
OPERATION
STARTING AND STOPPING
THE ENGINE
BEFORE STARTING THE ENGINE
1. Adjust the seat for a comfortable operating
position.
2. Fasten the seat belt.
STARTING AND STOPPING THE ENGINE
3. Check that the safety lock lever is in the
locked position.
4. Check that all levers and pedals are in the
neutral position.
5. Insert the key into the starter switch, turn it
to the ON position, then perform the
following inspections:
· The battery charge warning lamp (1) and
the engine oil pressure warning lamp (2)
light up.
· Press the switch at the rear of the boom
light to check if it turns on.
If either lamp does not light up, the bulb may
be burnt out or a wire may be damaged. Ask
your sales or service dealer for repair.
To Next Page
Loading...
Need help?
General
