8-4
OPTIONS
ATTACHMENT COMBINATION TABLE
The table below shows the bucket to be installed on the arm. Select a proper bucket by
following the table.
• Consult with Takeuchi before installing an optional attachment.
• Do not use any attachments not approved by Takeuchi. Doing so may cause safety
problems. Or, it may adversely affect the machine’s operation or service life.
• We will not be held responsible for any injuries, accidents or damage to its products
caused by the use by a non-approved attachment.
√ :Can be used.
∆ :Can be used only for light operations (digging and loading of dry and loose soil or mud)
— :Cannot be used.
ATTACHMENT COMBINATION TABLE
Bucket
Rated capacity
m
3
(cu. ft.)
Bucket cutting width
mm (inch)
Standard arm
880 mm (34.6 in.)
350W 0.022 (0.76) 350 (13.8) √
To Next Page
Loading...
Need help?
General
