8. Light up the inside of the outer element
(3) with a bulb, inspect it, and replace it if
there are small holes or thin spots.
9. Remove the cloth or tape applied in step
5.
10. Install the outer element (3).
11. Install the dust cup (2) with the “TOP”
mark at the top, then fasten it with the
clamps (1).
Every 250 Hours
Cleaning the Radiator Fins and Oil
Cooler Fins
WARNING
Wear required appropriate equipment
such as safety glasses and filter mask
when using compressed air, as metal
fragments or other objects can fly and
cause serious personal injury.
IMPORTANT: Be careful not to damage
the radiator fins and oil cooler fins when
cleaning them.
�
When using compressed air or
pressurized water, make sure the
pressure is no higher than 200 kPa (28
psi) and hold the nozzle sufficiently
away from the fins.
IMPORTANT: When using water, cover
the electrical system to prevent water
from getting in.
IMPORTANT: When operating the
machine in very dusty places, inspection
and maintenance should be performed
every day.
1. Open the rear cover (R.H.).
2. Blow compressed air on the radiator fins
and oil cooler fins to remove mud and
dirt stuck on them.
To Next Page
Loading...
