Parking the Machine
Parking
WARNING
� Park the machine on firm, level ground
and apply the parking device.
�
Before leaving the operator’s seat,
raise the safety lock lever to engage
the lock and stop the engine. If
any controls should be touched
accidentally when the safety lock
lever(s) is lowered, the machine will
move suddenly, and cause serious
injury or death.
1. Set the left and right travel levers to the
neutral position.
2. Return the throttle lever and idle the
engine at low speed.
3. Lower the bucket and dozer blade to the
ground.
4. Raise the safety lock lever(s) to engage
the lock.
5. Stop the engine and remove the key.
Refer to page 63 “Stopping the Engine”.
Inspection and Checks After
Stopping the Engine
1. Check for oil and water leakage and
inspect the working equipment, covers
and lower body. If any irregularities are
found, repair.
2. Fill the fuel tank.
Refer to page 106 “Checking the Fuel
Level”.
3. Remove any paper scraps or dirt from
the engine room.
4. Remove any mud from the lower body.
Locking
Be sure to lock the following places:
�
Engine hood
�
Mud guard
�
Manual storage compartment
�
Cab door
�
Left side cover
To Next Page
Loading...
