120
MAINTENANCE
Every 500 Hours
Replacing the Hydraulic Oil
Return Filter
Refer to page 109 “Replacing the Hydraulic
Oil Return Filter”.
Replacing the Fuel Filter
WARNING
� Do not smoke or permit open flames
while handling fuel or working on the
fuel system.
�
Stop the engine in a well-ventilated
place and allow it to cool down before
performing maintenance.
�
Clean up spilled fuel immediately.
1. Open the engine hood.
2. Close the lever (2).
3. Loosen the ring (3), then remove the case
(4) and element (5).
4. Clean the case (4).
5. Assemble the new element in the case
(4), then tighten the ring (3).
6. Open the lever (2) and bleed the air.
Refer to page 141 “Bleeding the air from
the fuel system”.
7. Start the engine and inspect for fuel
leakage.
To Next Page
Loading...
