Takeuchi TB23R - After the Fuel Runs out

141
TROUBLESHOOTING
If the Battery Goes Dead After the Fuel Runs Out
TROUBLESHOOTING
Disconnecting the jumper cables
Once the engine starts, disconnect the
jumper cables following the connection
procedure in reverse order.
1. Disconnect the clip of jumper cable (B)
from the problem vehicle’s engine block.
2. Disconnect the other clip of jumper cable
(B) from the rescue vehicle’s “–” terminal.
3. Disconnect the clip of jumper cable (R)
from the rescue vehicle’s “+” terminal.
4. Disconnect the other clip of jumper
cable (R) from the problem vehicle’s “+”
terminal.
Recharging
Have a Takeuchi sales or service outlet
recharge batteries that have gone dead.
Bleeding the Air from the Fuel
System
1. Add fuel.
2. Turn the starter key to the ON position
and hold it there for about 20 seconds.
The automatic air bleeder bleeds the air
from the fuel system.
Supplement: Air in the fuel system can
make it difficult to start the engine and
cause engine problems. Also bleed the air
when the fuel tank is emptied.
E4J006
4
1
3
2
R
B
Rescue vehicle battery
Problem vehicle battery
From engine block
PREHEAT
OFF
ON
START
E4D002