Hydraulic Breaker
� Do not pry with the chisel, and do not pry
while pounding.
�
Do not move the chisel while pounding.
�
Do not pound continuously for over 30
seconds on the same surface.
�
Do not pound with the cylinder fully
extended or contracted (at the stroke
end). Leave a margin of at least 5 cm
(2in.).
�
Do not pound with the arm perpendicular
to the ground surface.
Precautions on Operating
� Run the engine with 75% the maximum
speed.
�
Pound with the chisel perpendicular to
the surface you are pounding.
�
When pounding, press the chisel properly
against the object to be broken so as to
avoid pounding the air.
For handling of the breaker, read the
hydraulic breaker’s manual, provided
separately.
IMPORTANT: When mounting devices,
select devices suited for this machine.
For advice on selecting device, contact a
Takeuchi sales or service outlet.
Pressing force
To Next Page
Loading...
