Radio (for EU)
To cancel the beep tones ..................1, 7, 8
The unit emits a beep tone to confirm that
a function button has been pressed. To
cancel the function, follow the procedures
below.
Turn off the power by depressing the
ON/OFF button
.
With ACC on, press the ATP button
and the preset button 6
simultaneously until the display lights.
The beep tones are cancelled and boFF
is displayed.
To turn the beep tones on again, repeat
steps
and and b-on is displayed.
Tape operation
Selecting tape mode
Insert a cassette into the tape slot
and
the tape player will start.
Switching the tape direction ................2, 3
Press BUTTONS
and simultaneously.
�
When the tape reaches the end of one
side, the unit will automatically switch to
the opposite side of the tape.
Fast forward and rewind .......................2, 3
Press button
to fast-forward; press
button
to rewind the tape. To stop fast
forwarding or rewinding, lightly press the
opposite button
or to return to the
play mode.
During fast forward and rewind, the radio
monitor is activated. The unit receives the
station selected last.
Ejecting the tape ........................................4
P
ress the EJECT button
to eject a tape.
The system will return to the audio source
selected last.
Radio operation
Selecting radio mode
Each time the BAND button is pressed, the
selected band changes as shown below.
Radio tuning ................................................2
�
Automatic tuning
Press the TUNE/SEEK
or button
for more than 2 seconds.
When the button is released, the system
will start automatic tuning and stop at the
next receivable station.
�
Manual tuning
To select higher frequency stations, press
the
button for less than 0.5 seconds.
To select lower frequency stations, press
the
button for less than 0.5 seconds.
To quickly scan up or down in frequency,
press and hold the
or button.
Release the button when the display
approaches the desired frequency, then
press and release the button repeatedly
until the desired frequency is displayed.
A flashing decimal point in the frequency
display indicates that the system is
receiving a station 50 kHz higher than the
displayed frequency.
+
C4C031
2
5
DIR
ATP
TUNE/SEEK
CLOCK
1
2 3
4
5
6
P SCAN
ー
.
B A N D
3614
+
C4C032
1
DIR
ATP
TUNE/SEEK
CLOCK
1
2 3
4
5
6
P SCAN
ー
.
B A N D
3 4
2
FM1 FM2 MW
To Next Page
Loading...
