109
MAINTENANCE
After First 50 Hours (New Machines Only)
Engine oil filter
The engine oil filter is located under the
turbocharger.
1. Place a pan under the engine oil filter to
catch the waste oil.
2. Remove the filter drain plug (4) and drain
the oil from the filter case (6).
3. Loosen the bolt (5) and remove the filter
case (6).
4. Clean the inside of the filter case (6) and
install a new element (7).
5. Clean the filter stand and apply engine oil
to the O-rings.
6. Install the case (6) and tighten it with the
bolt (5), and then install the drain plug (4).
• Bolt (5) tightening torque: 44.1 N·m (32.5
ft-lb)
• Drain plug (4) tightening torque: 24.5
N·m (18.1 ft-lb)
7. Add oil up to the upper limit (H) of the
dipstick (1). Problems could arise if the oil
level is either too low or too high.
8. Tighten the oil supply cap (2).
9. Start the engine, run it at low idle for about
3 minutes, then stop it.
10. After about 10 minutes, inspect the oil
level.
To Next Page
Loading...