77
OPERATION
Parking the Machine
Inspection and Checks After
Stopping the Engine
1. Check for oil and water leakage and
inspect the dump body, covers and main
frame. If any irregularities are found,
repair.
2. Fill the fuel tank.
Refer to page 102 “Inspecting the Fuel
Level”.
3. Remove any paper scraps or dirt from the
engine room.
4. Remove any mud from the machine.
Locking
Be sure to lock the following places :
Cab door
Fuel filler cap
Engine hood
Side cover
Battery cover
Parking
WARNING
Park the machine on firm, level ground.
If you must park on a slope or incline,
block the machine securely to prevent
movement.
Before leaving the operator’s seat, set
the safety lock lever to the lock position
and stop the engine. If any controls
should be touched accidentally when
the safety lock lever is lowered, the
machine will move suddenly, and
cause serious injury or death.
1. Set the left control controller to the neutral
position.
2. Return the throttle controller and idle the
engine at low speed.
3. Place the safety lock lever to the lock
position.
4. Stop the engine and remove the key.
Refer to page 67 “Stopping the Engine”.
To Next Page
Loading...
Need help?
General