15
SAFETY
Starting with jumper cables
Use jumper cables only in the recommended
manner. Improper use of jumper cables can
result in battery explosion or unexpected
machine motion.
Refer to the section titled “If the Battery
Goes Dead” for proper instructions.
After starting the engine
After starting the engine, perform the
following operations and checks in a safe
place with no persons or obstacles in the
area. If any malfunctions are found, follow
the shutdown procedure and report the
malfunction.
Warm up the engine and hydraulic fluid.
Observe all gauges or warning instruments
for proper operation.
Listen for unusual noises.
Test engine speed control.
Operate each control to insure proper
operation.
In cold weather
Be careful of slippery conditions on
freezing ground, steps and hand holds.
In severe cold weather, do not touch any
metal parts of the machine with exposed
flesh, as flesh can freeze to the metal and
Cause injury.
Do not use ether or starting fluids on this
engine. These starting aids can cause
explosion and serious injury or death.
Warm up the engine and hydraulic fluid
before operating.
Starting Precautions
To Next Page
Loading...
Need help?
General