24
SAFETY
Transporting Precautions
Load and unload the machine
safely
The machine may roll or tip over or fall while
loading or unloading it. Take the following
precautions :
Select a firm, level surface and keep
sufficient distance from road shoulders.
Use loading ramps of adequate strength
and size. Maintain the slope of loading
ramps within 15 degrees.
Secure the ramps to the truck bed.
Keep the truck bed and loading ramps
clean of oil, clay, ice, snow, and other
materials which can become slippery.
Clean the tracks.
Block the transport vehicle so it can not
move.
Use a signal person when loading and
unloading the machine, and travel slowly
in first gear (low speed).
Never change course on the ramp.
Do not raise and / or swing the dump body
on the ramps and truck bed. The machine
may tip over.
Block both tracks and secure the machine
to the truck bed.
Transport the machine safely
Know and follow the safety rules, vehicle
code and traffic laws when transporting
the machine.
Consider the length, width, height and
weight of the transport vehicle with the
machine loaded on it when determining
the best route.
Do not hoist this machine
The machine is NOT equipped with any
hooking points for hoisting.
Never hoist the machine with any device
such as crane, etc.
Fasten to the suspension fitting
Ramp
15° or less
Distance between ramps
Stopper
To Next Page
Loading...