Takeuchi TCR50 User Manual

59
CONTROLS
Accessories
(7) TUNE button
Use this button to tune to a radio station.
Press and hold this button (
or ) for
two seconds or more to start seeking the
audible stations. The seeking stops when a
station is found. To cancel tuning in progress,
press the button again.
Pressing the
button will start seeking
stations with higher frequencies. Pressing
the
button will start seeking stations
with lower frequency. The frequency will
continuously be increased/decreased if the
or button is held pressed.
(8) BAND button
Use this button to select FM or AM. The
selected band and the receiving frequency
will be displayed on the LCD.
(9) VOL buttons
Use these buttons to control the sound
volume. Press the button
to increase
the volume and the button
to decrease
the sound volume. Press and hold each
button to continuously increase/decrease
the volume.
(10) MUTE button
Use this button to temporarily turn off the
sound output. If pressed, the “mute is on”
mark
appears on the LCD. Press this
button again to cancel mute.
(11) ZERO button
Use this button to set the minute to “00”
when it is between “55” and “59” or “01”
and “05”.
(12) AUX button
Use this button to choose which to listen
to, the radio or the external audio source
connected to the AUX-IN. If the external
source is chosen, the AUX display appears
on the LCD.
(13) AUX-IN jack
Use this jack to connect an external audio
source. Pull off the rubber cap and plug the
stereo mini-plug of the external audio device
into this jack. Be sure that the jack is closed
with the rubber cap when not in use.
Playing the radio
1. Turn the ignition key to the ACC or ON
position, and then press the power button
(1) to turn on the radio.
2. Select the band FM or AM with the band
button.
3. Select the station with the preset button or
the tuning button, and adjust the volume
with the volume button.
4. To turn off the radio, press the power
button.
Selecting a station — auto select
Press and hold the tune button
for two
seconds or more to start seeking stations
in the higher frequencies direction. Press
and hold the button
for two seconds or
more to start seeking stations in the lower
frequencies direction. The radio will stop
seeking when it finds an audible station and
start playing.
Selecting a station — manual select
The selection can be done manually. Press
the tune
button to seek stations with
higher frequencies. Press the tune
button
to seek stations with lower frequencies.
Presetting stations
1. Select the band (FM or AM) and the station
you want to preset.
2. To set the selected station to a preset
button, choose the button to be set and
then press and hold the button for three
seconds or more. The number of the
preset button chosen appears on the
LCD.

Takeuchi TCR50 Specifications

General

Brand	Takeuchi
Model	TCR50
Category	Construction Equipment
Language	English