Tally Dascom DL-200 User Guide V1.3
50
the printer will beep twice.
③ Status LED on, the printer enters upgrade mode.
① Run Dascom setup tool, select model Label Printer and USB interface.
② Select “Update Firmware” tab, then click “Browse” to locate the firmware/CG file, and then click
“Update”. May take about 20 seconds.
③ After loading the firmware, the Power LED, Error LED and Status LED blink.
④ When the printer beeps twice, and the three LEDs are on, turn the printer off and on.
To Next Page
Loading...
