Tally Dascom DL-200 - 8.3 TSPL Command Sets

Tally Dascom DL-200 User Guide V1.3
80
8.3 TSPL Command Sets
Commands
Function
SIZE
This command defines the label width and length
BLINE
This command sets the height of the black line and the user-defined extra label feeding
length each form feed takes.
BARCODE
This command prints 1D barcodes
QRCODE
This command prints QR code.
GAP
Defines the gap distance between two labels.
REFERENCE
This command defines the reference point of the label
SPEED
This command defines the print speed
DENSITY
This command sets the printing darkness
SET PEEL
This setting is used to enable/disable the self-peeling function. The default setting for this
function is off
SET CUTTER
This setting activates or deactivates the cutter and defines how many printed labels is to
be cut at one time
SET
PARTIAL_CUTTER
This setting activates or deactivates the cutter and defines how many printed labels is to
be cut at one time
SET TEAR
This command is used to enable/disable feeding of labels to gap/black mark position for
tearing off.
SET RIBBON
This setting is used to enable/disable ribbon sensor detection
DIRECTION
This command defines the printout direction
SHIFT
This command moves the label
’
s vertical position.
OFFSET
This command defines the selective, extra label feeding length each form feed takes,
which, especially in peel-off mode and cutter mode, is used to adjust label stop position,
so as for label to register at proper places for the intended purposes. The printer back
tracks the extra feeding length before the next run of printing.
BITMAP
This command draws bitmap images
REVERSE
This command reverses a region in image buffer
CLS
This command clears the image buffer.
PRINT
This command prints the label format currently stored in the image buffer
PUTPCX
This command prints PCX format images
KILL
This command deletes a file in the printer memory
DOWNLOAD
“
DOWNLOAD
”
is a header of the file that is to be saved in the printer
’
s memory