tau D820M - Page 35

35
MANUFACTURER’S DECLARATION OF INCORPORATION
(in accordance with European Directive 2006/42/EC App. II.B)
Manufacturer: TAU S.r.l.
Address: Via E. Fermi, 43 - 36066 Sandrigo (VI) - ITALY
Declares under its sole responsibility, that the product: Electronic control unit
designed for automatic movement of: Sliding gates
for: Condominium / Industrial use
Model: D820M Type: D820M
Serial number: see silver label
Commercial name: Control unit for 1 230 V AC three-phase gearmotor
Has been produced for incorporation on an access point (sliding gate) or for assembly with other devices
used to move such an access point, to constitute a machine in accordance with the Machinery Directive
2006/42/EC.
Also declares that this product complies with the essential safety requirements of the following EEC direc-
tives:
- 2014/35/EU Low Voltage Directive - 2014/30/EU Electromagnetic Compatibility Directive
Also declares that it is not permitted to start up the machine until the machine in which it is incorporated or of
which it will be a component has been identied with the relative declaration of conformity with the provisions of
Directive 2006/42/EC.
The following standards and technical specications are applied:
EN 61000-6-2; EN 61000-6-3; EN 60335-1; ETSI EN 301 489-1 V1.9.2; ETSI EN 301 489-3 V1.6.1;
EN 300 220-2 V2.4.1; EN 12453:2000; EN 12445:2000; EN 60335-2-103.
The manufacturer undertakes to provide, on suciently motivated request by national authorities, all infor-
mation pertinent to the quasi-machinery.
Sandrigo, 29/09/2021 Legal Representative
_________________________________________
Loris Virgilio Danieli
Name and address of person authorised to draw up all pertinent technical documentation:
Loris Virgilio Danieli - via E. Fermi, 43 - 36066 Sandrigo (VI) Italy